V Product Data Sheet Vandalite Lighting Ltd OXFORD Surface Fluorescent Range High impact resistant diffuser Mild steel powder coated body Wall or ceiling mounting Easy maintenance Description The OXFORD range of wall or ceiling mounted vandal resistant luminaires is suitable for commercial and industrial areas where potential damage is possible. The body is made from mild steel and has an epoxy powder coat in white as standard. The high impact resistant diffuser is available in opal or prismatic versions. The diffuser is held captive by mild steel endcaps which are secured to the body by 2 stainless steel anti-tamper screws. The diffuser is fitted and removed by removing one endcap and squeezing the diffuser out along the length of the fitting. The luminaire has a removable geartray which also acts as a reflector and is made from mild steel coated with an EPC finish in white. All luminaires are supplied with a power factor correction capacitor as standard. Cable entry is through a single 20mm central hole in the rear of the body. All luminaires in this range are designed to comply with BS EN 60598 and are suitable for operating in interior applications. Each luminaire also complies with European Directive 89/336/EEC and carries the CE mark. T8 IP20 PRODUCTS AVAILABLE CatalogueNo. Description OXF 136  36W4ft/1200mmluminaire OXF 158  58W5ft/1500mmluminaire OXF 170  70W6ft/1800mmluminaire OXF 236  2x36W4ft/1200mmluminaire OXF 258  2x58W5ft/1500mmluminaire OXF 270  2x70W6ft/1800mmluminaire /ES  electronic starterswitches /HF high frequency control gear /HFD high frequency dimmable control gear /EM 3 hr maintained emergency /O  opal diffuser /P  prismatic controller 600 1260 1560 1825 110 205 Dimensions Applications The OXFORD range of luminaires is suitable for wall or ceiling mounting in most commercial or industrial applications where vandal resistance is required. Such areas could be: Schools and Colleges Public areas Gymnasiums Sports halls Shopping malls Bus stations Local Authority buildings Maintenance For best results do not use abrasives or highly alkaline cleaners on the fittings. Do not use squeegees, razor blades or other sharp instruments. Do not clean the diffuser in hot sun or elevated temperatures. For removal of paints, marker pens, inks, lipstick etc., use Butyl Cellusolve on lens only. To remove labels, stickers etc., from the diffuser the use of kerosene, naphtha or white spirit is generally effective. After cleaning a final warm wash should be made using a mild soap solution and ending with a thorough rinse with cold water. Wipe off surface moisture from metalwork. Generally speaking, if the luminaires operate 12 hours each day, a re-lamping and cleaning programme every 24 to 36 months is advisable depending on which type of lamp is used. Standards All luminaires in the OXFORD range are designed and manufactured in accordance with the relevant sections of BS EN 60598. In addition, they comply with the requirements of European Directive 89/336/EEC and carry the CE mark. Each and every fitting undergoes stringent testing in excess of that required under the standard, to ensure that any possibility of luminaires arriving on site in anything other than full working order is kept to an absolute minimum. Technical Advice Our Technical Department would be pleased to advise customers with regard to any technical aspect of Vandalite luminaires. This includes a design service using state-of-the-art computer software, or manual calculations to ensure that each project receives the correct attention for the job. Vandalite Lighting  Ltd. Haley Hill Works Haley Hill Halifax West Yorkshire                  Tel: 01422 354254 HX3 6ED   Fax: 01422 356066 e-mail:enquiries@vandalite.com web site:www.vandalite.com All information, recommendation, or advice contained in this document or given by Vandalite Lighting Ltd., or an of its subsidiaries, affiliates, or authorised representatives, whether written or oral, is given in good faith, to the best of its knowledge, and based on current procedures in effect. The products of Vandalite Lighting Ltd. or if applicable, of its subsidiaries or affiliates are sold subject to Gener a Conditions of Sale printed at the rear of the currentcatalogue or available upon request. Nothing in this or any other document shall alter, vary or supersede, or operate to waive any of the General Conditions of Sale. Each user of the products shall convince themselves, through all available sources (including finished product test ing in its appropriate environment) of the suitability of the products supplied for its own particular purpose. Because actual use of the products by the user is beyond the control of Vandalite Lighting Ltd., its subsidiaries and affiliates, such use is within the exclusive responsibility of the user. Vandalite Lighting Ltd., its subsidiaries and affiliates cannot be held responsible for any loss incurred through incorrect or faulty use of the products. Information, recommendation and / or advice are neither made to infringe on any patents, nor to grant a license under any patent or intellectual property right of Vandalite Lighting Ltd. Or any of its subsidiaries or affiliated companies, nor to grant the right to file for any patent protection. We have a policy of continuous technical development and products and / or descriptions, and / or materials may be changed without prior public announcement or warning. V Vandalite Lighting  Ltd.