V Octane Canopy Lighting Range Product Data Sheet Vandalite Lighting Ltd Aluminium body and reflector Sealed to IP44 Toughened glass cover Description The range of OCTANE luminaires has been specifically designed for use in petrol station canopies and similar areas. The fittings are impact resistant and have a high efficiency reflector and low glare cross slat louvres. The body is made from pressed 1.6mm hard aluminium, primed and painted with an epoxy powder coat in white. The reflector is made from high grade 99.8 aluminium which has been dimpled, for performance, and oxidised. Integral cross vane louvres are used to restrict glare. The luminaire has an integral geartray which can be removed for maintenance purposes and to aid installation. A framed toughened glass cover is incorporated to enclose the luminaire to meet IP44 standard. All luminaires are supplied with a power factor correction capacitor as standard. Cable entry is through a single 20mm sealed gland on the rear of the fitting. All luminaires in this range are designed to comply with EN 60598 and are suitable for operating in normal exterior conditions with ambient temperatures not exceeding 30ºC. The luminaires are not zonal rated under the BASEEFA certification scheme and suitability should be checked with the Fire Officer. Each luminaire also complies with European Directive 89/336/EEC and carries the CE mark. IP44 PRODUCTS AVAILABLE CatalogueNo. Description OCT 250S 250W high pressure sodium OCT 400S 400W high pressure sodium OCT 250M 250W mercury OCT 400M 400Wmercury OCT 250MH 250W metal halide OCT 400MH 400W metal halide /RM  recessed mounting /SM  surface mounting /ASY  asymmetricalreflector /SYM  symmetricalreflector /RLY  warm-uprelay Dimensions 25 440 350 51 350 513 Applications TheOCTANErange of luminaires is suitable for use in most petrol station forecourt environments where an attractive aesthetic appearance and technical and economic attributes are required. Maintenance For best results do not use abrasives or highly alkaline cleaners on the fittings. Do not use squeegees, razor blades or other sharp instruments. Do not clean the diffuser in hot sun or elevated temperatures. For removal of paints, marker pens, inks, lipstick etc., use Butyl Cellusolve on diffuser only. To remove labels, stickers etc., from the diffuser the use of kerosene, naphtha or white spirit is generally effective. After cleaning a final warm wash should be made using a mild soap solution and ending with a thorough rinse with cold water. Wipe off surface moisture from metalwork. Generally speaking, if the luminaires operate only in the hours of darkness, a re-lamping and cleaning programme every 12 to 36 months is advisable depending on which type of lamp is used. It must be noted that High Pressure Sodium and Metal Halide lamps should be replaced before cycling occurs to prevent damage to the luminaire and control gear. Standards All luminaires in the OCTANE range are designed and manufactured in accordance with the relevant sections of BS EN 60598. In addition, they comply with the requirements of European Directive 89/336/EEC and carry the CE mark. Each and every fitting undergoes stringent testing in excess of that required under the standard, to ensure that any possibility of luminaires arriving on site in anything other than full working order is kept to an absolute minimum. Technical Advice Our Technical Department would be pleased to advise customers with regard to any technical aspect of Vandalite luminaires. This includes a design service using state-of-the-art computer software, or manual calculations to ensure that each project receives the correct attention for the job. All information, recommendation, or advice contained in this document or given by Vandalite Lighting Ltd., or an of its subsidiaries, affiliates, or authorised representatives, whether written or oral, is given in good faith, to the best of its knowledge, and based on current procedures in effect. The products of Vandalite Lighting Ltd. or if applicable, of its subsidiaries or affiliates are sold subject to Gener a Conditions of Sale printed at the rear of the currentcatalogue or available upon request. Nothing in this or any other document shall alter, vary or supersede, or operate to waive any of the General Conditions of Sale. Each user of the products shall convince themselves, through all available sources (including finished product test ing in its appropriate environment) of the suitability of the products supplied for its own particular purpose. Because actual use of the products by the user is beyond the control of Vandalite Lighting Ltd., its subsidiaries and affiliates, such use is within the exclusive responsibility of the user. Vandalite Lighting Ltd., its subsidiaries and affiliates cannot be held responsible for any loss incurred through incorrect or faulty use of the products. Information, recommendation and / or advice are neither made to infringe on any patents, nor to grant a license under any patent or intellectual property right of Vandalite Lighting Ltd. Or any of its subsidiaries or affiliated companies, nor to grant the right to file for any patent protection. We have a policy of continuous technical development and products and / or descriptions, and / or materials may be changed without prior public announcement or warning. Vandalite Lighting  Ltd. Haley Hill Works Haley Hill Halifax West Yorkshire                  Tel: 01422 354254 HX3 6ED   Fax: 01422 356066 e-mail:enquiries@vandalite.com web site:www.vandalite.com V Vandalite Lighting  Ltd.