V Product Data Sheet Vandalite Lighting Ltd NEPTUNE ? High Bay IP65 Industrial Lighting Range Computer designed aluminium reflector Aluminium gear housing Toughened glass reflector cover IP65 protection Excellent Photometric performance Description The NEPTUNE range of industrial discharge luminaires is sealed to IP65 protection and is suitable for the more demanding industrial environment. The gearbox is made from high temperature engineering grade plastic. The reflector is made of high grade 99.8 aluminium which has been highly polished and oxidised. The toughened glass reflector cover is sealed to provide IP65 rating. The luminaire has a galvanised geartray which can be removed for maintenance purposes. All luminaires are supplied with a power factor correction capacitor as standard. The ballast is multi-tapped for 230V to 250V operation. Cable entry is through a single 20mm weatherproof gland on the side of the gearbox. There is a top mounting chain ring for suspension mounting. All luminaires in this range are designed to comply with BS 4533 Part 2 1969 Section 2.2. They are suitable for operating in ambient temperatures not exceeding 30ºC. Each luminaire also complies with European Directive 89/336/EEC and carries the CE mark. IP65 PRODUCTS AVAILABLE CatalogueNo. Description NPT 150S 150W high pressure sodium NPT 250S 250W high pressure sodium NPT 400S 400W high pressure sodium NPT 250MH 250Wmetalhalide NPT 400MH 400W metal halide NPT 250M 250Wmercury NPT 400M 400Wmercury /RLY warm-up relay * Also available with SON Deluxe    and SON Plus lamps. 50 535 Dimensions Applications The NEPTUNE range of luminaires is suitable for most industrial environments where the mounting height is greater than 7 metres above the working plane and water or moisture is present. Such areas could be: Swimming pools Leisure centres Football terraces Sports stadiums Industrial premises Maintenance For best results do not use abrasives or highly alkaline cleaners on the fittings. Do not use squeegees, razor blades or other sharp instruments. Do not clean the diffuser in hot sun or elevated temperatures. To remove labels, stickers etc., from the diffuser the use of kerosene, naphtha or white spirit is generally effective. After cleaning a final warm wash should be made using a mild soap solution and ending with a thorough rinse with cold water. Wipe off surface moisture from metalwork. Generally speaking, if the luminaires operate only in the hours of darkness, a re-lamping and cleaning programme every 12 to 36 months is advisable depending on which type of lamp is used. It must be noted that High Pressure Sodium and Metal Halide lamps should be replaced before cycling occurs to prevent damage to the luminaire and control gear. Standards All luminaires in the NEPTUNE range are designed and manufactured in accordance with the relevant sections of BS EN 60598. In addition, they comply with the requirements of European Directive 89/336/EEC and carry the CE mark. Each and every fitting undergoes stringent testing in excess of that required under the standard, to ensure that any possibility of luminaires arriving on site in anything other than full working order is kept to an absolute minimum. Technical Advice Our Technical Department would be pleased to advise customers with regard to any technical aspect of Vandalite luminaires. This includes a design service using state-of-the-art computer software, or manual calculations to ensure that each project receives thecorrect attention for the job. All information, recommendation, or advice contained in this document or given by Vandalite Lighting Ltd., or an of its subsidiaries, affiliates, or authorised representatives, whether written or oral, is given in good faith, to the best of its knowledge, and based on current procedures in effect. The products of Vandalite Lighting Ltd. or if applicable, of its subsidiaries or affiliates are sold subject to Gener a Conditions of Sale printed at the rear of the currentcatalogue or available upon request. Nothing in this or any other document shall alter, vary or supersede, or operate to waive any of the General Conditions of Sale. Each user of the products shall convince themselves, through all available sources (including finished product test ing in its appropriate environment) of the suitability of the products supplied for its own particular purpose. Because actual use of the products by the user is beyond the control of Vandalite Lighting Ltd., its subsidiaries and affiliates, such use is within the exclusive responsibility of the user. Vandalite Lighting Ltd., its subsidiaries and affiliates cannot be held responsible for any loss incurred through incorrect or faulty use of the products. Information, recommendation and / or advice are neither made to infringe on any patents, nor to grant a license under any patent or intellectual property right of Vandalite Lighting Ltd. Or any of its subsidiaries or affiliated companies, nor to grant the right to file for any patent protection. We have a policy of continuous technical development and products and / or descriptions, and / or materials may be changed without prior public announcement or warning. Vandalite Lighting  Ltd. Haley Hill Works Haley Hill Halifax West Yorkshire                  Tel: 01422 354254 HX3 6ED   Fax: 01422 356066 e-mail:enquiries@vandalite.com web site:www.vandalite.com V Vandalite Lighting  Ltd.