V Product Data Sheet Vandalite Lighting Ltd NEMESIS ? zone 2 Industrial Lighting Range Glass reinforced polyester body Sealed to IP66 Stippled acrylic diffuser Suitable for hazardous areas rated Zone 2 Description The NEMESIS range of fluorescent luminaires is suitable for use in hazardous areas which are rated Zone 2. The body is made of glass reinforced polyester and is available in grey colour only. The diffuser is made of acrylic and is available in stippled clear finish. The diffuser is held captive by a number of nylon toggle clips as standard, but can be supplied with stainless steel clips to special order. The diffuser is sealed to the frame by a full perimeter gasket to prevent ingress of dust and moisture to the fitting. The luminaire is has an ingress protection code of IP66. The luminaire has a removable geartray which also acts as a reflector. It is made from mild steel which has been finished with an epoxy powder coat in white. Fittings are supplied with electronic start control gear as standard. All luminaires are supplied with a power factor correction capacitor as standard. Cable entry is through 20mm holes in each end of the body and fixing is by two 6mm holes in the rear of the body. All luminaires in this range are designed to comply with EN 60598 and BS 5345 Part 7 ? 1979 and are suitable for operating in hazardous areas rated Zone 2 where the ambient temperature does not exceed 30ºC. All luminaires are BASEEFA Ex N approved. Each luminaire also complies with European Directive 89/336/EEC and carries the CE mark. Dimensions 11 IP66 PRODUCTS AVAILABLE CatalogueNo. Description NMS 158 5ft/1500mm zone 2 - single NMS 170 6ft/1800mm zone 2 - single NMS 258 5ft/1500mm zone 2 - twin NMS 270 6ft/1800mm zone 2 ? twin /SP  suspension set /EM 3 hour integral emergency EEx em II T4 T8 Ex 186 116 1612 1872 1100 Applications The NEMESIS range of luminaires is suitable for use in hazardous areas rated Zone 2. Such areas could be: Certain paint booth and spraying areas Chemical storage areas Garage pits Petro-chemical installations Plant rooms Industrial production areas Oil refineries Maintenance For best results do not use abrasives or highly alkaline cleaners on the fittings. Do not use squeegees, razor blades or other sharp instruments. Do not clean the diffuser in hot sun or elevated temperatures. To remove labels, stickers etc., from the diffuser the use of kerosene, naphtha or white spirit is generally effective. After cleaning a final warm wash should be made using a mild soap solution and ending with a thorough rinse with cold water. Wipe off surface moisture from metalwork. Generally speaking, if the luminaires operate only in the hours of darkness, a re-lamping and cleaning programme every 12 to 36 months is advisable depending on the number of hours that the fittings are used. Standards All luminaires in the NEMESIS range are designed and manufactured in accordance with the relevant sections of BS EN 60598. In addition, they comply with the requirements of European Directive 89/336/EEC and carry the CE mark. Each and every fitting undergoes stringent testing in excess of that required under the standard, to ensure that any possibility of luminaires arriving on site in anything other than full working order is kept to an absolute minimum. Technical Advice Our Technical Department would be pleased to advise customers with regard to any technical aspect of Vandalite luminaires. This includes a design service using state-of-the-art computer software, or manual calculations to ensure that each project receives the correct attention for the job. All information, recommendation, or advice contained in this document or given by Vandalite Lighting Ltd., or an of its subsidiaries, affiliates, or authorised representatives, whether written or oral, is given in good faith, to the best of its knowledge, and based on current procedures in effect. The products of Vandalite Lighting Ltd. or if applicable, of its subsidiaries or affiliates are sold subject to Gener a Conditions of Sale printed at the rear of the currentcatalogue or available upon request. Nothing in this or any other document shall alter, vary or supersede, or operate to waive any of the General Conditions of Sale. Each user of the products shall convince themselves, through all available sources (including finished product test ing in its appropriate environment) of the suitability of the products supplied for its own particular purpose. Because actual use of the products by the user is beyond the control of Vandalite Lighting Ltd., its subsidiaries and affiliates, such use is within the exclusive responsibility of the user. Vandalite Lighting Ltd., its subsidiaries and affiliates cannot be held responsible for any loss incurred through incorrect or faulty use of the products. Information, recommendation and / or advice are neither made to infringe on any patents, nor to grant a license under any patent or intellectual property right of Vandalite Lighting Ltd. Or any of its subsidiaries or affiliated companies, nor to grant the right to file for any patent protection. We have a policy of continuous technical development and products and / or descriptions, and / or materials may be changed without prior public announcement or warning. Vandalite Lighting  Ltd. Haley Hill Works Haley Hill Halifax West Yorkshire                  Tel: 01422 354254 HX3 6ED   Fax: 01422 356066 e-mail:enquiries@vandalite.com web site:www.vandalite.com V Vandalite Lighting  Ltd.